Troy Weber’s phone rang in the early morning hours. When he saw the caller ID, his heart began to pound. After three years as Fleet Manager, he knew what the message would be: another injury, most likely to a driver. He hoped he was wrong or at least that it was not serious, but his mind was already racing over how he’d be able to manage the routes with a driver down.

Failed attempts

It seemed like the accidents, especially the slips-and-falls, should be preventable, but extra training on ‘three points of contact’ had not solved the problem. Even adding grab-handles to the cab seemed like a good idea, but that had actually added arm and shoulder injuries to some of the slip-and-fall cases. He had to stop drivers from getting hurt on the job.

This time

Joe, a long-time employee, had gotten hurt. His foot slipped exiting the cab and he twisted his ankle hard enough to tear a ligament. He would be out of work for a minimum of three-months. Troy felt terrible because Joe was such a hard worker who always followed safety precautions.

A common occurrence

According to the U.S. Department of Labor, “truck drivers have the highest number of nonfatal injuries and illnesses that require days off from work across all occupations (a total of 55,710 injuries in 2014). In fact, tractor-trailer truck drivers are three times more likely than the typical American worker to have an injury or illness that requires days off from work. The injuries that are most likely to cause them to miss work result from slips, trips and falls.”1

A closer look

A closer look at the fleet’s truck steps showed metal steps that are perforated to allow for water and ice to pass through rather than collect on the surface. But the serrated steel had worn down since the drivers may exit the trucks up to 50 times a day. Worse, this type of step had no slip-resistant material at the leading edge of the step, where slips most often occur. The foot of a driver descending the steps would hit that edge and, without any added traction on the radius, would slip.

Eliminate the hazard

Troy knew that the most effective controls involve elimination of the hazards. Luckily, he figured out that an anti-slip surface bonded to the truck steps could prevent this particular type of injury in the future. Better still, he discovered a similar solution could apply to ladders, running boards, and ramps – most any surface that becomes slippery and likely to cause slips-and-falls.

Government statistics show that truck drivers are especially prone to slip-and-fall injuries. After Troy consulted with Erick Schuetz at Safeguard Technology, he confidently set a plan in motion to protect his drivers.

Read the statistics on trucker injuries for yourself– and take steps to prevent injuries on your own vehicles.

Two tone steps covers and mat

Testimonials