SAFEGUARD® Cover Sizes

STEP COVERS

Standard Sizes

Width of Step:	19-24”	25-30”	31-36”	37-42”	43-48”	49-54”
Step Cover Length (A):	18”	24”	30”	36”	42”	48”
Step Cover Depth (B):	Each of the above lengths (A) is available in depths (B) of 3, 6, 9, and 12”

Non-Standard Sizes

Safeguard can supply any anti-slip step cover, with the following limits in length:

up to 120” (10 feet) long in FRP, with up to a maximum depth of 12”
up to 48” (4 feet) long in steel, with any depth needed

NOTE: The depth of the tread covered depends on the circumstances. All SAFEGUARD® Step Covers wrap over the front edge, where most slips occur. However there can be special situations that require extra care. For example:

For high heel traffic on grating steps, most or all of the tread must be covered.
For frequently wet or oily steps – cover at least 6”

LADDER RUNG COVERS

Sizes

SAFEGUARD® steel Ladder Rung Covers (LRC) are made to fit any diameter rung between ¾” and 2”, while the fiberglass LRC are pultruded through specific dies and therefore are for certain rung diameters only. For Example:

	Metal Covers	FRP Covers
Length (A)	Up to 48”	Up to 48”
For Rung Diameters (B)	Made to fit any rung diameter from ¾” to 2”	3/4”, 1”, 1-1/4" 1-1/2", 1-3/4", 2"
Installation	Tack weld Adhesive Mechanical Fastener	Adhesive Mechanical Fastener

WALKWAY COVERS

Sizes

All Walkway Covers are made to order – when ordering, the Width (A) and the Length (B) are required.

The largest size for steel Walkway Covers is 48” x 48”, for Pultruded FRP 96” x 48”, and for vinyl 48” x 24”.

PIPE & CABLE COVERS

Sizes

Pipe and Cable safety covers are available in one cross-sectional profile, with the maximum length being 10 feet. The diagram shown here illustrates the various dimensions of the profile.